3. Overview Module
Overview module is mainly used to display the system and hardware panel status.
3.1 System Information
3.1.1 Aircraft Information
The first line shows the selected flight model software and flight simulate software corresponding to the Profile. When user change the Active profile under Options/System page, the information display here changes.
The last line shows the connection status between iFSim.Ready software and the flight model software. When iFSim.Ready is connected to the flight model software, a green Connect will display. When iFSim.Ready disconnects from the flight model software, a red Disconnect will display.
3.1.2 Profile Information
Profile information shows on the up middle part of the Overview page.
The first line shows the file name of currently active Profile, which corresponds to the choice in the Profile list under Options/System page.
The last line shows the current status of the Profile file, which is controlled by the Start Profile and Stop Profile buttons under Options/System page. When the Profile file is running, a green Run will display. When the Profile file is not running, a red Stop will display.
3.1.3 SDK Information
SDK information shows on the up right part of the Overview page.
The first line shows the IP and Port iFSim.Ready used to send data, which is set under SDK page.
The second line shows the IP and Port iFSim.Ready used to receive data, which is also set under SDK page.
The last line shows the current running status of the SDK, which is controlled by Start SDK button and Stop SDK button under the SDK page. When the SDK is running, a green Run will display. When the Profile file is not running, a red Stop will display.
3.2 Hardware Information
3.2.1 CAN Device Status
CAN device status shows just followed the Hardware label. When a USB-CAN-II or CandleLight Device is turned on, a green CAN Device will display. Otherwise a red CAN Device will display.
3.2.2 Panel Connect Status
This part shows all the available CNFSimulator A320 component panels. When any panel is connected to the CAN network, a green Connect will display at the lower right corner of the panel. Otherwise a red Disconnect will display there.
